Peak 100 Self-Supporting Glazing Bar

Glazing bar is the ideal bar for a fully professional appearance; all mountings & fixings are fully encased in the capping. The bars, designed by C & A, are fully self-supporting up to 4M in length/projection, a 6M bar is available but will require additional support.

Suitable for 16, 25 & 32mm thick polycarbonate. Capped top & bottom by a Brown or White uPVC cladding to give a good thermal insulation. Ideal for carports, canopies and conservatory roofs. For the first and last glazing bar in your run of sheeting use edge beads on the outside edge of the glazing bar, listed below, Please make sure you use the 16mm edge bead for 16mm sheets, 25mm edge bead for 25mm sheets & of course 32mm edge beads for 32mm sheets.

End Caps and Pivot Mounting Brackets are listed seperately are listed seperately at the end of the glazing bar section but you can tick the box when ordering the bar to also add these to your order.

Brown Glazing Bars

Peak 100 Pivot Mounting Brackets

Pivot Mounting Brackets are used to secure both peak 75 & 100 glazing bars to the wall plate and front beam. 1 Pack comes with 2 mounting brackets to fix both top & bottom ends of the glazing bar, Stainless Steel Pivot Pin & 8 Stainless Steel Fixing Screws

16mm Edge Beads

10mm Edge Beads are used with Glen & Avon system glazing bars when using 6 & 10mm sheets. They are used to provide a finish to the first and last bar in roof. They have been specially designed to mimic a polycarbonate sheet so as to allow the correct loading when the top cap of the glazing bar is pushed home ensuring a uniform pressure on the polycarbonate sheets when fixed down.

25mm Edge Beads

25mm Edge Beads are used with Avon or the Peak system glazing bars when using 25mm sheets. They are used to provide a finish to the first and last bar in roof. They have been specially designed to mimic a polycarbonate sheet so as to allow the correct loading when the top cap of the glazing bar is pushed home ensuring a uniform pressure on the polycarbonate sheets when fixed down.

Peak 100 Glazing Bar End Cap

This cap is a universal cap designed for use with the Peak 100 system taking sheets from 16mm to 32mm.

Conversions Utility

Please Note This Utility Is For Guidance Only. C & A Building Plastics Cannot Be Held Responsible For Any Inaccuracies.

Important Notice

All Plastic Building Materials should be kept flat during transport and storage. If the items are to be stacked then care must be taken not to overload the stack so as to crush the lower products, it it extremely important that all materials are covered with a LIGHT PROOF sheet to prevent direct sunlight over heating the interior of the stack.